There is one problem I notice. If you have two solutions and projects in
solution 2 reference assemblies in solution 1. (I have both solutions open
at the same time).
If I change the interface of a class in solution 1 and recompile, I see R#
refreshing solution 2, but it does not notice the changed interface. This
used to work until 249 for sure. R# was refreshing and noticing all changes.
Now, it only refreshes and eats more memory and gives errors about the
changed interface even if it compiles correctly.
(The last build I used was 249 and it worked at that time).
I also have a feeling that compilation takes MUUUCHH longer with 253. I can
clearly notice that.
Could you guys add some flag that disables ALL R#. I like it's functionlity
but I realy need it only from time to time.
If I leave it running its so blody slow that I can hardly use VS anymore.
Especially after 5-6-10 debugging sessions that I usually kill. I can easly
get R# into 200-300Mb usage.
I usually disable it from Addins but I keeps enabling itself back whenever I
end a debug session or I press a shortcut. I would like to keep it
"disabled" until I realy want it enabled. Then disabled it again.